Installation Guide

Follow these professional steps to achieve a flawless installation of your panels. Proper preparation and technique will ensure long-lasting results and optimal acoustic performance.

Tools Required

• Measuring tape
• Spirit level (or laser level)
• Pencil for marking
• Panel adhesive (polyurethane-based recommended)
• Caulking gun
• Fine-tooth saw or mitre saw (for cutting)
• Safety glasses and dust mask
• Clean cloth
• Spacers (optional)

Before You Begin

• Store panels flat in a dry environment at room temperature
• Inspect all panels for damage before starting
• Plan your layout and calculate the number of panels needed, adding 10% for cuts and waste

Step 1: Wall Preparation

The wall surface must be clean, dry, flat, and structurally sound. Remove any loose paint, wallpaper, dust, or debris. Fill holes and cracks with appropriate filler and sand smooth. For best results, the wall should be primed. Ensure the wall is completely dry before proceeding.

Step 2: Planning & Layout

Measure your wall carefully and plan the panel arrangement. Mark a level horizontal reference line using a spirit level. For the best visual result, start from the center of the wall and work outward, or begin from the most visible corner. Dry-fit panels before applying adhesive to confirm your layout.

Step 3: Installing Start Panels (If Applicable)

If your design includes start/finish panels, install the start panel first. Apply adhesive in a zigzag pattern on the back of the panel, staying 2cm from the edges. Press firmly against the wall, aligning with your reference line. Hold for 30-60 seconds.

Step 4: Applying Adhesive

Apply panel adhesive in a zigzag or serpentine pattern across the back of the panel. Keep adhesive approximately 2cm away from all edges to prevent squeeze-out. For larger panels, apply additional adhesive in the center for maximum bond strength.

Step 5: Panel Installation

Position the panel against the wall, aligning with your reference marks. Press firmly and evenly across the entire surface. Hold in place for 30-60 seconds to allow initial adhesion. For heavy panels, use temporary supports or painter's tape until the adhesive cures. Continue installing panels, ensuring tight joints between each panel.

Step 6: Cutting Panels

When cutting is required, measure carefully and mark the cut line on the back of the panel. Use a fine-tooth saw for clean cuts. Always wear safety glasses and a dust mask when cutting. Sand cut edges lightly if needed for a smooth finish.

Step 7: Installing Finish Panels & Corners

Complete your installation with finish panels and corner pieces. Apply adhesive using the same technique and press firmly into place. Ensure all edges are properly aligned for a professional appearance.

Step 8: Final Touches

Wipe away any adhesive residue immediately with a clean, damp cloth. Inspect all joints and edges. Allow 24-48 hours for full adhesive cure before applying any stress to the panels.

Important Tips

• Work in a well-ventilated area
• Do not install in high-humidity environments or directly over moisture sources
• For bathroom or kitchen areas, ensure proper ventilation and avoid direct water contact

Maintenance

Your panels feature a German anti-fingerprint waterproof coating for easy maintenance. Simply wipe with a soft, dry cloth for regular cleaning. For stubborn marks, use a slightly damp cloth. Avoid abrasive cleaners, harsh chemicals, or excessive moisture.

Need Help?

If you have questions about installation or need professional installation services, please contact our support team at info@stellaspaceco.com. We're here to help ensure your project is a success.